2026-11-19 · David Miller
Why Your Drain Keeps Clogging in Englewood: 7 Causes Snaking Won't Fix
If a drain keeps clogging after it has been snaked, the snake opened a path through the clog but left the cause in place. The seven usual culprits are a grease layer on the pipe wall, hair caught on the stopper or a rough spot, roots regrowing through a cracked joint, a sag (belly) where solids settle, scale or rust narrowing old metal pipe, a pipe with too little slope, and habits that keep feeding the clog. Each needs a different fix, and the pattern of your clogs usually tells you which it is.
Why snaking alone doesn't end it
A cable auger bores a hole through a blockage and pulls some of it back. On grease, scale or a root mat, much of the material stays stuck to the pipe wall, so the opening narrows again. That is why the second clog often arrives faster than the first. Cleaning the whole wall (jetting), removing what keeps feeding the clog, or repairing the pipe is what breaks the cycle.
Tell which cause you have
| Pattern | Most likely cause | What ends it | |---|---|---| | Kitchen sink, every few months | Grease layer in the branch line | Hydro jetting; keep grease out | | Bathroom sink or shower, slowly worse | Hair on stopper or in trap | Clean stopper/trap; hair catcher | | Whole house slow, worse after storms of laundry | Roots or sludge in main line | Root cutting, camera, then schedule or repair | | Main line clogs at the same distance every time | Sag, offset or crack at that spot | Camera locates it; spot repair | | Old house, every drain gradually slower | Scale in cast-iron or galvanized pipe | Descaling or replacing that section | | New work, clogs since day one | Too little slope or a bad fitting | Correct the installation | | Toilets clog with wipes or paper | Habits | Change what goes down; nothing else needed |
1. A grease layer
Cooking fat cools and sticks to the pipe wall, especially in long, nearly level kitchen branch lines. Food catches on it. Snaking opens the middle; the walls stay coated. Hydro jetting scours the full wall, which is why it lasts longer on kitchen lines.
2. Hair on a stopper or rough spot
Bathroom sinks, tubs and showers clog when hair wraps around the pop-up rod or catches on a burr. Snaking deeper doesn't help if the anchor point is the stopper itself. Pull and clean it, and fit a hair catcher.
3. Roots regrowing
Tree roots are a leading cause of sewer blockages; a USDA Forest Service review reported them responsible for more than half of blockages in the studies it covered. According to NC State Extension, roots cannot create cracks in a sewer pipe; they exploit existing cracks or gaps. Cutting removes the roots but not the gap, so they return. A camera shows how many joints are affected, which decides between scheduled cutting and repair.
4. A sag (belly)
When part of the line sinks, water and solids sit in the low spot. Clogs keep forming at the same distance from the cleanout. Cleaning gives temporary relief; only fixing the sag ends it. A camera inspection records the distance and depth.
5. Scale and rust in old metal pipe
Cast-iron drains and galvanized branch lines narrow from the inside as they corrode, leaving a rough surface that grabs debris. Many older homes still have them. Descaling can restore the bore in sound cast iron; badly corroded galvanized pipe is usually replaced.
6. Too little slope
A drain needs a steady fall so water carries solids. Lines installed too flat, often in remodels or basement finishes, clog repeatedly from the day they're built. Cleaning can't fix geometry.
7. Habits
Wipes, paper towels, grease, coffee grounds and fibrous food scraps cause many repeat toilet and kitchen clogs. If the pipe checks out fine on camera, this is the likely answer, and it's the cheapest one to fix.
What not to do
Repeated chemical drain cleaners rarely remove the cause and can damage older metal pipe and finishes. Don't keep paying for the same snaking without asking what came out on the cable and whether the line should be inspected.
When to get a camera inspection
- The same drain clogged twice within a year.
- Clogs return at the same distance from the cleanout.
- More than one fixture is affected (see main line or one drain).
- You are being quoted for a sewer repair or replacement.
The bottom line
A drain that keeps clogging has a reason. Match the pattern to the cause, fix that cause, and the cycle stops. Our recurring drain clogs service starts with your clog history and ends with a straight answer: habit, cleaning or pipe. We work across Englewood, including the older streets around Cushing Park.
Sources: [USDA Forest Service, Randrup et al. 2001](https://research.fs.usda.gov/treesearch/45998); [NC State Extension, tree roots and sewer lines](https://union.ces.ncsu.edu/tree-roots-and-sewer-lines/).