2026-11-18 · David Miller
Tree Roots in a Clay Sewer Line in Englewood: Cut, Jet or Replace?
If roots are in your clay sewer line, you have three real choices: cut them out and repeat on a schedule, cut and then jet the line for a cleaner result that lasts longer, or repair the joints the roots are entering (spot repair, lining or replacement) so they stop coming back. The right answer depends on how many joints are affected and whether the pipe is still round and intact, which only a camera inspection can show.
Why roots get into clay pipe
Clay sewer laterals were laid in short sections joined end to end, with joints sealed by mortar or early gaskets. Over decades those joints loosen and crack. Warm, moist air and a trickle of water escape, and nearby roots follow the moisture into the gap. Roots exploit existing cracks and gaps; they do not break a sound pipe. Inside, fine roots grow into a mat that catches paper and grease until the line slows or backs up. Older Englewood homes can still have these laterals, sometimes running under mature street and yard trees.
Option 1: Root cutting (cable machine)
A sectional or drum machine with a root-cutting head shears roots off at the pipe wall and restores flow. It is the quickest way out of a backup and is safe for most clay pipe in fair condition.
- Good for: light to moderate roots at a few joints; restoring flow in an emergency.
- Limits: cuts leave stubs at the joint; roots grow back through the same joint; how fast varies with the tree, the season and how open the joint is, so your own backup history is the best guide.
- Repeat interval: set by experience. If a line backed up after 14 months, schedule cutting at about 10-12 months.
Option 2: Cut, then hydro jet
After cutting restores flow, jetting flushes fine root hairs, grease and debris and leaves cleaner walls. Lines tend to stay open longer than with cutting alone.
- Good for: heavy fine roots and grease together; lines where cutting alone failed early.
- Limits: high pressure is not used on cracked, broken or collapsing clay; that is why the camera goes in first.
Option 3: Fix the entry points
If roots enter at one or two joints, a spot repair of that section can end the problem. If many joints are affected, lining (a resin liner cured inside the old pipe) or replacement of the lateral may cost less over time than years of cutting. Lining needs the old pipe to still hold its shape; replacement is for pipe that is broken, collapsed or badly sagging.
Decide by what the camera shows
| Camera finding | Usual best choice | |---|---| | Fine roots at 1-3 joints, pipe round | Cut (or cut + jet), then schedule | | Heavy root mass at one joint, rest good | Cut, then spot repair that joint | | Roots at many joints, pipe round | Compare long-term cutting vs lining | | Cracked or broken sections | Repair or replace those sections | | Sag holding water plus roots | Repair; cleaning will not stop recurring clogs |
Ask for the footage and the distance to each root entry. It lets you get comparable repair quotes. See what a drain camera inspection shows.
Do root killers work?
Root-control products (foaming herbicide treatments and copper sulfate crystals) are sold for sewer lines. They can slow regrowth after roots are mechanically cut, but they don't clear a blocked line and won't fix the joint the roots are using. Read the label and treat them as a supplement to cutting, not a substitute.
Will cutting roots kill my tree?
The roots inside the pipe are a small fraction of a mature tree's root system, and cutting them does not normally harm a healthy tree. Removing a tree does not remove roots already in the pipe, and a new tree planted over the lateral will create the same problem later.
Who owns which part of the line?
We cannot tell you where your responsibility ends, and it can depend on your address. Before any repair, ask Englewood Utilities or your sewer provider who owns which section of the line, and check whether your homeowners policy covers service line repair; many don't unless an endorsement was added.
Common mistakes
- Snaking repeatedly without ever looking at the pipe.
- Jetting an old clay line before inspecting it.
- Waiting for a backup instead of scheduling cuts before the known regrowth point.
- Planting fast-growing, water-seeking trees over the sewer route.
What we check first
Where the cleanout is, how long since the last backup, what came out on the cable (fine hair roots or a dense mass), and whether the camera shows the pipe still round. Those four facts decide the plan. We give a written quote after inspection; the price depends on the line, the problem and access.
Need roots cleared? Our sewer line cleaning service covers root cutting, jetting and inspection. To lower the chance of a repeat, see how to prevent tree root clogs in older Englewood homes. We also serve Cherry Hills Village, where larger lots can mean longer laterals.